FURNACE TUNE-UP & MAINTENANCE SERVICES IN PHOENIX, AZ
OUR 21-POINT FURNACE & HVAC TUNE-UP SERVICES INCLUDE:
1. CHECK THERMOSTAT OPERATION
Our furnace and HVAC tune-up services include an audit of the thermostat to ensure the furnace operates properly with the current settings.
2. INSPECT PLENUM
Inspect the plenum on the furnace for faulty components, including if the pan gasket needs to be replaced.
3. INSPECT DUCTS
Each HVAC tune-up appointment includes an inspection of the air ducts to check for obstructions, including debris, dirt, and pet dander.
4. INSPECT FOR AIR DUCT LEAKS
Inspect ducts for air leaks in the system that may effect the efficiency of your heating system.
5. CHECK CONDENSATION DRAIN PAN
Check water level in the condensation drain pan to make sure pooling doesn’t take place.
6. CHECK CONDENSATE DRAIN
Check the heating unit’s condensation drain for any clogs and for proper drainage.
7. CHECK INDOOR BLOWER MOTOR
Check for a bad blower motor and to make sure it operates correctly.
8. CHECK BLOWER MOTOR RUN CAPACITOR
Check if the blower motor run capacitor holds the correct electrical charge and runs properly.
9. INSPECT CONDITION OF BLOWER WHEEL
Inspect if the blower motor powers the wheel correctly and that belts are in good working order.
10. CHECK OF MEASURE AIR FLOW
Check the velocity that air travels through the ventilation system.
11. CHECK & TEST SAFETIES
Check that all safety components are in place and in tact to prevent any future breakdowns.
12. CHECK ELECTRICAL WIRING OF SYSTEM
Check for any faulty wiring and known issues with your unit’s model number.
13. CHECK OPERATION
Check that the unit works properly both inside and out.
14. CONDITION COMPRESSOR CONTRACTOR
Ensure compressor contractor runs as expected and its integration with related components.
15. CHECK RELAYS
Check that your unit’s relay switch works correctly.
16. TEST RUN CAPACITORS
Test that the motors attached to the run capacitor function appropriately.
17. CHECK SYSTEM STARTING COMPONENTS
Check each starting component to ensure it functions correctly in sequence.
18. CHECK REFRIGERANT PRESSURES
Check that the unit’s refrigerant suction line has the correct amount of pressure.
19. CHECK CONDENSER MOTOR OPERATION
Check that the condenser motor operates correctly plus at the right speed and voltage.
20. CHECK INSULATION ON TUBES & PANELS
Check that the heaters tubes and panels are properly insulated.
21. CALCULATE OPERATING EFFICIENCY
Ensure your heater operates efficiently and at what rate.